Marking the Finished Panel’s Face
When preparing glass panels for a multi-room renovation, clearly mark the finished face to avoid confusion during installation. According to the National Glass Association, document the exterior/interior orientation and coating surfaces, numbering from outdoors inward. Use a non-permanent marker or tape on the finished face to indicate this orientation. This practice helps ensure that coatings such as low-E surfaces are correctly oriented, preserving performance and aesthetics.
Measuring Origin on Shop Drawings
Shop drawings must specify a consistent measurement origin, typically from a fixed corner or edge of the unit. For multi-room projects, choose an origin that aligns with the architectural plans and hardware templates. Vitro Architectural Glass advises obtaining written hardware templates and finished dimensions from the responsible supplier before specifying fabrication details. This prevents costly errors, especially when holes or cut-outs are involved.
Checklist for Ordering and Receiving
Before issuing a purchase order, verify that the shop drawing includes all ply thicknesses, edge treatments, and coating designations. Confirm the documented origin point for measurements and ensure it matches the panel marking. When receiving glass, cross-check the markings on the panel face against the shop drawing to confirm orientation and dimensions. This thorough approach reduces field adjustments and aligns with best practices for heat-treated and coated glass fabrication.
Sources
Prepared with AI assistance using the references above.




